Melco EMT 10T Specifications download pdf (Page 95)

3. Slide the picker assembly out of the picker bracket mount.

When re-attaching the picker link to the picker assembly, refer to the alignment

section of this chapter for the alignment procedure for the picker position.

Movable Knife

1. Remove the screws holding the needle plate. Remove the needle plate.

2. Remove the screws holding the front and rear bed covers and remove the covers.

3. Lift the forward end of the connecting link from the pin on the movable knife

drive arm (see Figure 4-5).

4. Push the movable knife all the way back until it stops.

5. By rotating counter clockwise, loosen the hex head screw holding the movable

knife to the top of the knife drive arm.

6. Rotate the movable knife out of the adjustable fixed knife, then remove the hex

head screw and the movable knife.

7. Place the new movable knife on the top of the knife drive arm, positioning the

alignment hole in the knife over the alignment pin in the arm.

8. Apply Loctite 222 screw adhesive (or equivalent) and install the hex head screw

and snug it with your fingers.

mounting

screws

Picker

Bracket

Mount

Picker

Picker Link

Swivel Pivot

set screw

External

Retaining

Ring

Picker

Base and

shaft

Figure 4 - 4

Movable Knife 4 - 7

110291-01, Rev D 4. Trimmer Maintenance

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 127 128

No comments

Melco EMT 10T Specifications Page 95