Melco EMT 10T Specifications download pdf (Page 108)

Home Position Sensor

If the movable knife is mechanically adjusted correctly for home position, but the

"Trimmer Not Home" message comes ON, the home position sensor needs

adjustment. This adjustment is to move the indicator tab (attached near the cam) to

the middle of the photo sensor when the movable knife is at the home position (see

Figures 4-13 and 4-14). To make the adjustment:

1. Loosen the two socket head cap screws that hold the indicator.

2. Move the indicator forward or backward the required amount.

3. Retighten the screws.

WARNING! Keep clear of the moving parts that are exposed

during the operation of the next step(s).

4. Repeat the TRIM IMMEDIATE cycle and recheck for the message. Repeat the

adjustment as needed until the message no longer comes on after the TRIM

IMMEDIATE cycle.

Photo Sensor

Movable Knife

"home" position

indicator adjustment

screws

Indicator Tab

Connecting Link screws for

adjusting Movable Knife

"home" position

Engage solenoid pin

into cam groove by

pushing here with flat

bladed screw driver

trimmer

solenoid

solenoid pin end

shown engaged

in cam groove

Figure 4 - 14

4 - 20 Trimmer Adjustment Procedures

EMT 10T Technical Manual Melco Embroidery Systems

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 127 128

No comments

Melco EMT 10T Specifications Page 108