Melco EMT 10T Specifications download pdf (Page 114)

Grabber Adjustment

The grabber blade travel is adjusted at the transition bracket where the guide rod

from grabber drive mechanism is attached with a set screw.

1. Refer to Figure 4-2 and grasp the grabber blade at the location between the top

grabber blade cover and the front grabber blade cover where the finger is

pointing. Figure 4-19 also shows this area.

2. Manually move the grabber blade all the way forward and all the way back one

time to check if the blade is binding somewhere in its travel. If so, find the

mechanical bind and correct it.

DO NOT USE OIL TO TRY TO CORRECT THE BIND!

3. Turn the peripheral ON and go to the Function menu. Select Trim Immediate and

perform one trim immediate function.

4. Locate the grabber blade guide just behind Velcro wiper bar at the bottom of the

needle case area (see Figure 4-19).

5. The the grabber blade should be extending out the front of the grabber blade

guide and directed toward the middle of the Velcro wiper bar as shown in

Figure 4-19.

6. To adjust for location in Step 5, loosen the 2 mounting/adjustment screws

holding the grabber blade guide (see Figure 4-19) and move the guide until the

grabber blade is directed toward the middle of the Velcro wiper bar. Retighten

the screws.

7. Manually move the grabber blade all the way forward.

mounting/adjustment

screws (2 each)

X = 2 1/2 inches

(+/- 0.10 ")

Grabber

Blade Guide

Velcro

Wiper Bar

Grabber Blade

(when home)

tip of Grabber Blade

when extended

Figure 4 - 19

4 - 26 Trimmer Adjustment Procedures

EMT 10T Technical Manual Melco Embroidery Systems

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 127 128

No comments

Melco EMT 10T Specifications Page 114