Melco EMT 10T Specifications download pdf (Page 40)

3. Refer to the Caution statement at the beginning of this procedure and be certain

the Y drive belt in the other Y carriage is secure and with some amount of

tension.

4. Move the X beam to the rear until it mechanically stops.

5. Position a hex wrench through the access hole (see Figure 2-19) and into one of

the two cap head screws in the front of the frame for adjusting the belt tension

(see Figure 2-20).

6. Note the location of the wrench handle and rotate the socket head cap screw

approximately 3 revolutions counter clockwise.

7. Move to the other access hole associated with tensioning the belt and rotate that

socket head cap screw the same amount as the first.

8. If replacing the Y drive belt on the left side of the peripheral, remove the Y home

flag to gain access to the belt clamp.

9. Push the now slack belt aside far enough to get a hex wrench through the access

holes in the base of the Y carriage mounting bracket and into the socket head

cap screws securing the Y drive belt to the under side of the Y carriage block.

Remove the screws and belt mounting clamp.

10. Slide the old belt out from around the two pulleys and prepare to install a new

belt.

11. Place a new belt into position around the pulleys and attach the belt to the

under side of the Y carriage block by reversing the previous steps for removing

the belt and mounting clamp.

truss head

screw

(1 of 5)

right

side

cover

right side Y

belt tension

adjustment

access holes

the left side cover

and Y belt tension

adjustment access

holes are a mirrored

duplicate of the

right side

Figure 2 - 19

2 - 26 X Beam Assembly

EMT 10T Technical Manual Melco Embroidery Systems

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 127 128

No comments

Melco EMT 10T Specifications Page 40